Here is my new Frame......
This project was made from one piece of 1" x 6", nails and a router...that's it!!
He started by measuring my digital frame and went from there. I would give you exact measurements, but all digital frames are different sizes, depths, etc.. Just start by first measuring the frame you have and adjust the 1" x 6" to fit your frame. My frame is 19 1/4" long and 16 1/2" tall and the width of my digital frame is 9".
He routed the inset of the frame so the digital frame rested inside of it. Measure the depth of the frame and adjust the router to make it fit your frame....
Made a couple of wooden stands for the frame to stand up.......
and tadaaaa......Lookie how that frame fits in there perfectly....
I primed it a grey color so the black paint would take to it better.....
Purchased an iron piece from Hobby Lobby for $4.99 and spray painted it turquoise....
Here's a hint...if you are going to paint screws, place them in a scrap piece of peg board and paint away.....
After the primer on the frame dried, I painted it black.....
Distressed the heck out of it and put a coat of polyurethane on it....
I also distressed the iron piece....just took my sandpaper block and ran over the top of it....
Measured and screwed in my iron piece and placed my digital frame in it, securing it with screen clips.
Hope you have a great week...Thanks for stopping by!!
Linking to....
.







































































































